Skip to main content
Skip table of contents



This guide takes you through setting up Crunch for use with Cyclr, as well as installing the Connector.

Setup & Authentication

Remote Setup

Prior to setting up Crunch for use with Cyclr, you will need a Crunch account, which can be created here.

To use the Crunch connector, you will need to register for a Crunch developer account. This can be done by filling in this form to register.

Once your developer account is setup, you will receive an email containing your Client ID which you will use to authenticate your Crunch Connector.

Cyclr Connector Installation

When installing the Crunch Connector, enter the following values:



Client ID

The Client ID provided by Crunch for your developer account.

Client Secret

This should be left blank.


The domain to make calls to e.g.:

API Version

The version of the API to use, e.g.: v1

You will then be prompted to login to your Crunch account by entering the following values




The Username (usually the email address) of your Crunch account.


The Password of your Crunch account.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.